Version 1.7.2 — January 2019
| Fixed | Issue retaining data after memory error during power up |
FIXED
Version 1.7.1 — October 2017
| Fixed | Issue preventing data download via Data Hub |
Version 1.7.0 — April 2017
| Fixed | Issue preventing resume from halt functionality via USB. |
| Fixed | Issue causing the heart rate connectivity icon to not clear properly between initializations. |
Version 1.6.0 — October 2016
| Improved | Updated screen displayed when device is charging. |
| Improved | Updated screen displayed when device is not configured for data collection. |
| Fixed | Calibration and data storing issues when wirelessly resuming data collection. |
| Fixed | Intermittent screen distortion issue when device changes modes. |
Version 1.5.0 — July 2016
| Improved | Devices now report fully charged status to ActiLife |
| Improved | Changed battery warning indication level to 10 percent |
| Improved | Provides more accurate battery readings while devices are charging |
| Fixed | USB download issue |
| Fixed | Devices unexpectedly resetting |
| Fixed | Wear sense calibration countdown irregularities |
| Fixed | Issues entering Central Plus mode |
Version 1.4.0 — November 2015
- Added the ability to resume data collection from HALT mode due to low or dead battery via the CentrePoint Sync Mobile App without the need to download data first.
- Added the ability to use a single unit for proximity to be both receiver and beacon.
- Improved battery life when device is used with CentrePoint Sync Mobile App.
- Made clock size consistent throughout screens. Clock used to change to a smaller font when low battery screen was displayed.
- Fixed an issue where the IMU data was incorrectly time-stamped. This allows the primary accelerometer and IMU data to be synchronized. Latest ActiLife release is needed in conjunction with this firmware.
- Improved correlation between on-board epoch data and ActiLife processed epochs from the Raw data.
Version 1.3.0 — July 2015
- Made general battery improvements through software optimizations.
- Retain daily step and calorie totals across initialization with ActiSync.
- Added support for Wireless SDK integration.
- Fixed a bug where initializing with a subject weight less than 1 kg caused undefined behavior.
- Fixed a bug that could cause logging a heart rate monitor disconnect event prior to the start time.
- Throttle down processor after 10 seconds of idle time while charger to reduce heat buildup.
- Made changes to manufacturing test modes to improve production efficiency.
Version 1.1.0 — November 2014
- Rotate the primary accelerometer output 90 degrees so that the X, Y and Z axes are aligned with the IMU output.
- Removed the wear detection status icon from the display.
- Tweaked rising and falling voltage thresholds for USB plug detection.
- Fixed bounds checking used for internal memory capacity tests.
- Tweaked the capacitor discharge cycle to remove reduce noise in wear detection measurements.